Graham Family Organization

Back with version 1.0b2 of Fennec, I've tried using the browser on my N810. It would open, but when trying to access complex web pages (e.g., http://www.pbs.org), Fennec would crash. If I ran Fennec from the command line, I would get the following message:

pure virtual method called
terminate called without active exception
Aborted

We have a Maytag Neptune (MAH5500BWW) washer that would go through the complete wash cycle and then get to the spin portion of the cycle and silently skip from minute 7 to minute 0 without really doing much. After poking around a various places, I didn't find the solution to my problem on-line, but I did figure it out, so I thought I would post what I found on-line. I also posted this solution on: http://www.fixya.com/support/t2322035-will_drain_but_wont_spin

Here are a few interesting hosted developer sites:

http://cvsdude.com/

http://wush.net

http://www.hosted-projects.com/

https://gforgegroup.com/ondemand/

For others, see the following link under the "Hosting" section:

http://svn.collab.net/repos/svn/branches/scheme-bindings/www/links.html

Hi, I just thought I would try out the blogging feature for Drupal and Graham.org. So far, it doesn't seem to bad. Hopefully this works out smoothly for other folks as well.

In any case, the "Private" access is really intended for people that are able to log in, namely, family members. It is still possible to do "Public" blogs as well. You should be able to change the access provided to others for a blog entry at any time.

Enjoy,

Paul